Sains Malaysiana 46(2)(2017): 181–188

http://dx.doi.org/10.17576/jsm-2017-4602-01

 

Peak Friction Angle Estimation from Joint Roughness Coefficient of Discontinuities of Limestone in Peninsular Malaysia

(Anggaran Sudut Geseran Puncak daripada Pekali Kasar Kekasaran Ketakselanjaran Batu Kapur

di Semenanjung Malaysia)

 

AILIE SOFYIANA SERASA1,2, GOH THIAN LAI*, ABDUL GHANI RAFEK3, AZIMAH HUSSIN1, LEE KHAI ERN4 & TUAN RUSLI MOHAMED5

 

1Geology Program, School of Environmental and Natural Resource Sciences, Faculty of Science

and Technology, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

2Chemical and Petroleum Engineering Department, Faculty of Engineering, Technology and Built Environment, UCSI University, 56000 Cheras, Kuala Lumpur, Malaysia

 

3Department of Geosciences, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, 31750 Tronoh, Perak Darul Ridzuan, Malaysia

 

4Institute for Environment and Development (LESTARI), Universiti Kebangsaan Malaysia

43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

5Jabatan Mineral dan Geosains Malaysia, Perak, Jalan Sultan Azlan Shah, 31400 Ipoh, Perak

Darul Ridzuan, Malaysia

 

Received: 1 March 2016/Accepted: 6 June 2016

 

 

ABSTRACT

The peak friction angle (φpeak) roughness of discontinuity surfaces is a value that is fundamental to the understanding of shear strength of geological discontinuities, considering its importance in determining the mechanical properties of the discontinuity surface. It is however, both time and cost demanding to determine the peak friction angle as it requires an extensive series of laboratory tests. This paper presents an approach in the form of an experimentally determined polynomial equation to estimate peak friction angle of limestone discontinuity surfaces by measuring the Joint Roughness Coefficient (JRC) values in a field survey study, and applying the fore mentioned empirical correlation. A total of 1967 tilt tests and JRC measurements were conducted in the laboratory to determine the peak friction angles of rough limestone discontinuity surfaces. The experimental results were analyzed and correlated to establish a polynomial equation of φpeak = -0.0635JRC2 + 3.95JRC + 25.2 with coefficient of determination (R2) of 0.99. The laboratory results were also compared with theoretical results calculated from Barton's linear equation. The results shown that estimation of peak friction angles were more accurate using the newly proposed polynomial equation since the percentage differences between measured and calculated peak friction angles is less than 6% compared to estimation from Barton's linear equation where the percentage of differences is less than 11%. The proposed correlation offers a practical method for estimation of peak friction angles of discontinuity surfaces of limestone from measurement of JRC in the field.

 

Keywords: Discontinuity surface roughness; empirical correlation; joint roughness coefficient (JRC); limestone; peak friction angle

 

 

ABSTRAK

Sudut geseran puncak (fpeak) kekasaran permukaan ketakselanjaran adalah nilai asasi kepada pemahaman tentangkekuatan ricih ketakselanjaran geologi, memandangkan kepentingannya dalam menentukan sifat mekanik permukaan ketakselanjaran. Walau bagaimanapun, ia memerlukan masa dan kos yang tinggi untuk menentukan sudut geseran puncak kerana ia memerlukan satu siri ujian makmal yang menyeluruh. Kertas ini membentangkan suatu pendekatan dalam bentuk persamaan polinomial yang dijalankan secara makmal untuk menganggar sudut geseran puncak permukaan ketakselanjaran batu kapur dengan mengukur Pekali Kekasaran Kekar (JRC) dalam kajian survei lapangan dan menggunakan empirikal korelasi yang disebutkan sebelum ini. Sejumlah 1967 ujian kemiringan dan pengukuran JRC telah dijalankan di dalam makmal untuk menentukan sudut geseran puncak permukaan kasar ketakselanjaran batu kapur. Keputusan ujian telah dianalisis dan dikorelasi untuk mewujudkan persamaan polinomial fpeak= - 0.0635JRC2 + 3.95JRC+ 25.2 dengan pekali penentuan (R2) sebanyak 0.99. Keputusan makmal juga dibandingkan dengan keputusan secara teori yang dikira daripada persamaan linear Barton. Hasil menunjukkan bahawa anggaran sudut geseran puncak adalah lebih tepat dengan menggunakan persamaan polinomial baru yang dicadangkan memandangkan perbezaan peratusan antara sudut geseran puncak yang diukur dengan yang dikira adalah kurang daripada 6% berbanding dengan anggaran daripada persamaan linear Barton dan peratusan perbezaan adalah kurang daripada 11%. Korelasi yang dicadangkan memberikan suatu kaedah praktikal untuk anggaran puncak sudut geseran permukaan ketakselanjaran batu kapur daripada pengukuran JRC dalam lapangan.

Kata kunci: Batu kapur; kekasaran ketakselanjaran permukaan; korelasi empirikal; pekali kekasaran kekar (JRC); sudut geseran puncak

REFERENCES

Barton, N. 1973. Review of a new shear strength criterion for rock joints. Engineering Geology 7: 287-332.

Barton, N. & Choubey, V. 1977. The shear strength of rock joints in theory and practice. Rock Mechanics 10: 1-54.

Coulomb, C.A. 1773. Essai sur une application des regies des maximis et minimis a quelques problemes de statique relatifs a 1'architecture. Mem. Pres. Par Div. Savants. 7: 343-382.

Fecker, E. & Rengers, N. 1971. Measurement of large scale roughness of rock planes by means of Profilograph and geological compass. Rock Fracture, Proc. of Int. Symp. Rock Mech Nancy 1: 18.

Foo, K.Y. 1990. Geology and mineral resources of the Taiping- Kuala Kangsar Area, Perak Darul Ridzuan. Geol. Survey Malaysia, Map Rept. 1, p. 145.

Gobbett, D.J. 1964. The lower paleozoic rocks of Kuala Lumpur, Malaysia. Federation Museum’s Journal 9: 67-79.

Ghani Rafek, A., Goh, T.L. & Hariri Arifin, M. 2012. Korelasi pekali kekasaran kekar dengan sudut geseran puncak satah ketakselanjaran batuan Syis, Semenanjung Malaysia. Sains Malaysiana 41(3): 293-297.

Ghani, R.A., Goh, T.L., Hariri, A.M. & Baizura, Y.N. 2011. Field and laboratory-based approach for the determination of friction angle of geological discontinuities of Malaysian granites. Asean J. Sc. Technol. Dev. 28(2): 151-155.

Goh Thian Lai & Abdul Ghani Rafek. 2012. Correlation of joint roughness coefficient (JRC) and peak friction angles of discontinuities of Malaysian Schists. Earth Science Research 1(1): 57-63.

Goh, T.L., Abdul Ghani, R., Ailie, S.S., Azimah, H. & Lee, K.E. 2016. Use of ultrasonic velocity travel time to estimate uniaxial compressive strength of granite and schist in Malaysia. Sains Malaysiana 45(2): 185-193.

Goh, T.L., Ghani Rafek, A. & Hariri Arifin, M. 2014a. Correlation of joint roughness coefficient with peak friction angles of discontinuity planes of granite, Peninsular Malaysia. Sains Malaysiana 43(5): 751-756.

Goh, T.L., Abdul Ghani, R., Ailie, S.S., Norbert, S. & Lee, K.E. 2014b. Empirical correlation of uniaxial compressive strength and primary wave velocity of Malaysian granites. Electronic Journal Geotechnical Engineering 19(E): 1063-1072.

Goh, T.L., Abdul Ghani, R., Ailie, S.S., Norbert, S., Lee, K.E. & Azimah, H. 2015a. Empirical correlation of uniaxial compressive strength and primary wave velocity of Malaysian Schists. Electronic Journal Geotechnical Engineering 20: 1801-1812.

Goh, T.L., Abdul Ghani, R., Ailie, S.S., Norbert, S., Azimah, H. & Lee, K.E. 2015b. Correlation of ultrasonic velocity slowness with uniaxial compressive strength of schists in Malaysia. Electronic Journal Geotechnical Engineering 20: 12663-12670.

Jones, C.R. 1976. Geology and Mineral Resources of Perlis, North Kedah and the Langkawi Islands. District Memoir No.17. Geological Survey Malaysia. Kuala Lumpur: Jabatan Penyiasatan Kajibumi Malaysia.

Norbert, S., Michael, C., Mairead, d.R. & Abdul Ghani, R. 2013. Point based assessment: Selecting the best way to represent landslide polygon as point frequency in landslide investigation. Electronic Journal Geotechnical Engineering 18(d): 775-784.

Norbert, S., Michael, C., Mairead, D.R., Abdul Ghani, R. & Rodeano, R. 2015a. Time series assessment on landslide occurrences in an area undergoing development. Singapore Journal of Tropical Geography 36: 98-111.

Norbert, S., Muhammad Fahmi, A.G., Goh, T.L., Abdul Ghani, R., Azimah, H., Rodeano, R. & Lee, K.E. 2015b. Assessment of rockfall potential of limestone hills in the Kinta Valley. Journal of Sustainability Science and Management 10(2): 24-34.

Norbert, S., Rodeano, R., Abdul Ghani, R., Goh, T.L., Noran, N.N.A., Kamilia, S., Nightingle, L.M., Azimah, H. & Lee, K.E. 2016. Rock mass assessment using geological strength index (GSI) along the Ranau-Tambunan Road, Sabah, Malaysia. Research Journal of Applied Sciences, Engineering and Technology 12(1): 108-115.

Norbert, S., Rodeano, R., Nightingle, L.M., Juhari, M.A., Abdul Ghani, R. & Goh, T.L. 2014. Lineaments and their association with landslide occurrences along the Ranau-Tambunan Road, Sabah. Electronic Journal Geotechnical Engineering 19(c): 645-656.

Patton, F.D. 1966. Multiple modes of shear failure in rock. Proc. 1st International Congress of Rock Mechanics, Lisbon 1: 509-513.

Priest, S.D. 1993. Discontinuity Analysis for Rock Engineering. London: Chapman & Hall.

 

 

*Corresponding author, email: gdsbgoh@gmail.com