Sains Malaysiana 47(1)(2018): 59–66

http://dx.doi.org/10.17576/jsm-2018-4701-07

 

Stability Assessment of Limestone Cave: Batu Caves, Selangor, Malaysia

(Penilaian Kestabilan Gua Batu Kapur: Batu Caves, Selangor, Malaysia)

 

GOH THIAN LAI1*, WONG JIA MANG1, ABDUL GHANI RAFEK2, AILIE SOFYIANA SERASA3, NUR AMANINA MAZLAN1, AINUL MARDHIYAH MOHD RAZIB1, AZIMAH HUSSIN1, LEE KHAI ERN4 & TUAN RUSLI MOHAMED5

 

1Geology Program, School of Environmental and Natural Resource Sciences, Faculty of Science and Technology, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

2Department of Geosciences, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, 31750 Tronoh, Perak Darul Ridzuan, Malaysia

 

3School of Engineering (Petroleum), Asia Pacific University of Technology & Innovation (APU),
Technology Park Malaysia, Bukit Jalil, 57000 Kuala Lumpur, Federal Territory, Malaysia

 

4Institute for Environment and Development (LESTARI), Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

5Department of Mineral and Geoscience Malaysia Perak, Jalan Sultan Azlan Shah, 31400 Ipoh, Perak Darul Ridzuan, Malaysia

 

Received: 18 November 2016/Accepted: 21 June 2017

 

ABSTRACT

The limestone hill of Batu Caves is slowly being turned into a recreation park for slope climbing, base jumping and cave exploring. Quantitative assessment on the stability of the cave is essential to ensure the safety of tourists and visitors. The aim of this study was to quantitatively assess the stability of Gua Damai, Batu Caves, Selangor, Malaysia by using the Q system for rock mass classification, together with other factors such as cave width and thickness of the cave roof. The stability of the limestone cave wall was evaluated using Slope Mass Rating (SMR). A discontinuity survey conducted along the slopes beneath the opening of the cave showed that the rock mass comprised of four major joint sets labeled as J1, J2, J3, and J4 with the dip directions and angles of 110˚/73˚, 325˚/87˚, 243˚/39˚ and 054˚/30˚, respectively. The result of kinematic analysis showed that the dip direction/dip angle of a potential wedge failure was 051˚/59˚. By referring to the ratio of cave roof thickness with cave width, the results showed that the cave is stable. Based on the relationship between Q system and the cave width, the stabilities of Section 4 of Gua Damai is stable while Section 1, 2, 3, 5, 6, 7 and 8 require supports. Based on SMR, the cave walls stability at Portion c, d, and f were not stable while Portion a, b, e and g were stable. Overall, the most stable part of the cave is Section 4 followed by Sections 5 and 2. Sections 1, 3 and 8 are moderately stable while Sections 6 and 7 have poor stability.

 

Keywords: Cave stability assessment; limestone; Slope Mass Rating (SMR); Q system

 

ABSTRAK

Bukit batu kapur Batu Caves dijadikan sebagai taman rekreasi secara perlahan perlahan bagi aktiviti mendaki cerun, lompat tinggi dan penerokaan gua. Penilaian kuantitatif kestabilan gua adalah penting bagi menjamin keselamatan pelancong dan pengunjung. Tujuan kajian ini adalah untuk menilai kestabilan Gua Damai, Batu Caves, Selangor, Malaysia secara kuantitatif menggunakan Sistem Q untuk pengelasan jasad batuan dan faktor lain seperti kelebaran gua dan ketebalan bumbung gua. Kestabilan dinding gua dinilai menggunakan Perkadaran Jasad Cerun (SMR). Satu survei ketakselanjaran telah dijalankan di sepanjang cerun di bawah bukaan gua menunjukkan jasad batuan mengandungi empat set kekar utama iaitu J1, J2, J3 dan J4 dengan arah dan sudut kemiringan masing-masing bernilai 110˚/73˚, 325˚/87˚, 243˚/39˚ dan 054˚/30˚. Keputusan analisis kinematik menunjukkan arah dan sudut kemiringan kegagalan baji yang berpotensi ialah 051˚/59˚. Merujuk kepada nisbah antara ketebalan bumbung gua dengan kelebaran gua, keputusan menunjukkan bahawa gua adalah stabil. Berdasarkan kepada hubungan antara sistem Q dan kelebaran gua, Bahagian 4 Gua Damai adalah stabil manakala Bahagian 1, 2, 3, 5, 6, 7 dan 8 memerlukan sokongan. Berdasarkan SMR, kestabilan dinding gua pada Bahagian c, d, dan f adalah tidak stabil manakala Bahagian a, b, e dan g adalah stabil. Secara keseluruhan, bahagian gua yang paling stabil ialah Bahagian 4 diikuti oleh Bahagian 5 dan 2. Bahagian 1, 3 dan 8 adalah sederhana stabil manakala Bahagian 6 dan 7 mempunyai kestabilan yang rendah.

 

Kata kunci: Batu kapur; penilaian kestabilan gua; Perkadaran Cerun Batuan (SMR); sistem Q

REFERENCES

Abdul Ghani, R. & Goh, T.L. 2015. A systematic approach for the quantification of rock slope stability. In Engineering Geology for Society and Territory. Volume 2, edited by Lollino, G., Giordan, D., Crosta, G.B., Corominas, J., Azzam, R., Wasowski, J. & Scirra, N. London: Springer.

Barton, N. 1995. The influence of joint properties in modelling jointed rock masses. 8th ISRM Congress 3(3): 1023-1032.

Bieniawski, Z.T. 1989. Engineering Rock Mass Classifications: A Complete Manual for Engineers and Geologists in Mining, Civil, and Petroleum Engineering. New York: John Wiley & Sons Inc.

Gobbett, D.J. 1965. The Lower Palaeozoic rocks of Kuala Lumpur, Malaysia. Fed. Mus. J. 9: 67-79.

Gobbett, D.J. & Hutchison, C.S. 1973. Geology of the Malay Peninsula. New York: Wiley Interscience.

Goh, T.L., Abdul Ghani, R., Nur Ailie, S.S., Norbert, S., Lee, K.E. & Azimah, H. 2015a. Empirical correlation of uniaxial compressive strength and primary wave velocity of Malaysian schists. Electronic Journal Geotechnical Engineering 20: 1801-1812.

Goh, T.L., Abdul Ghani, R., Nur Ailie, S.S., Norbert, S., Azimah, H. & Lee, K.E. 2015b. Correlation of ultrasonic velocity slowness with uniaxial compressive strength of schists in Malaysian. Electronic Journal Geotechnical Engineering 20: 12663-12670.

Goh, T.L., Abdul Ghani, R., Nur Ailie, S.S., Azimah, H. & Lee, K.E. 2016a. Use of ultrasonic velocity travel time to estimate uniaxial compressive strength of granite and schist in Malaysia. Sains Malaysiana45(2): 185-193.

Goh, T.L., Ainul, M.M.R., Nur Amanina, M., Abdul, G.R., Nur Ailie, S.S. & Tuan, R.M. 2016b. Rock slope stability assessment using slope mass rating (SMR) method: Gunung Lang Ipoh Malaysia. Scholars Journal of Engineering and Technology (SJET) 4(4): 185-192.

Goh, T.L., Md. Selim, R., Abdul Ghani, R., Nur Ailie, S.S., Azimah, H. & Lee, K.E. 2016c. Assessment of ultimate bearing capacity based on the Hoek-Brown failure criterion. Sains Malaysiana45(11): 1603-1607.

Hatzor, Y.H., Talesnick, M. & Tsesarsky, M. 2002. Continuum and discontinuum stability analysis of the bell shaped caverns at Bet Guvrin, Israel. International Journal of Rock Mechanics & Mining Sciences 39(7): 867-886.

Ibrahim Komoo & Ibrahim Abdullah. 1983. Ketakselanjaran dan kaedah pengukuran di lapangan. Sains Malaysiana12(2): 119-140.

International Society for Rock Mechanics. 1981. Rock characterization, testing and monitoring. In ISRM Suggested Methods, edited by Brown, E.T. Oxford: Pergamon Press.

International Society for Rock Mechanics. 1985. Suggested method for determining point load strength, International Journal Rock Mechanics Mining Sciences and Geomechanics Abstracts 22(2): 51-60.

Muhammad Fahmi, A.G., Norbert, S., Goh, T.L., Tuan Rosli, T.M. & Abdul Ghani, R. 2016. Kajian ketumpatan lineamen dalam penilaian potensi jatuhan batuan di kawasan Lembah Kinta. Sains Malaysiana45(12): 1887-1896.

Norbert, S., Muhammad Fahmi, A.G., Azimah, H., Goh, T.L., Abdul, G.R., Noraini, S., Tuan, R.T.M. & Lee, K.E. 2015. Assesssment of rockfall potential of limestone hills in the Kinta Valley. Journal of Sustainability Science and Management 10(2): 24-34.

Romana, M. 1985. New adjustment ratings for application of Bieniawski classification to slopes. Int. Symp. on the Role of Rock Mechanics ISRM. pp. 49-53.

Tan, B.K. 2001. Engineering geology of limestone in Malaysia. Journal of the Geological Society of China 75(3): 316-324.

Tan, B.K. 2006. Urban geology of Kuala Lumpur and Ipoh, Malaysia. IAEG. p. 24.

Waltham, T. 2002. The engineering classification of karst with respect to the role and influence of caves. Int. J. Speleol. 31(1/4): 19-35.

Waltham, A.C. & Fookes, P.G. 2003. Engineering classification of karst ground conditions. Quarterly Journal of Engineering Geology and Hydrogeology 38: 101-118.

Yunus Abd. Razak. 2014. Geological Map of Peninsular Malaysia. 9th ed. Kuala Lumpur: Mineral and Geoscience Malaysia.

 

 

*Corresponding author; email: gdsbgoh@gmail.com

 

 

 

previous