Sains Malaysiana 48(1)(2019): 173–181

http://dx.doi.org/10.17576/jsm-2019-4801-20

 

Effect of Alkali Treatment on Interfacial and Mechanical Properties of Kenaf Fibre Reinforced Epoxy Unidirectional Composites

(Kesan Rawatan Alkali kepada Sifat Antara Muka dan Mekanik Komposit Uniarah Serabut Kenaf Memperkukuh Epoksi)

ZILONG REN1,2,3, CHUNHONG WANG1,2,3*, QI ZUO1,2,3, SHERAZ HUSSAIN SIDDIQUE YOUSFANI4, NOOR INTAN SAFFINAZ ANUAR5,6, SARANI ZAKARIA5 & XIAOLING LIU7

 

1School of Textile, Tianjin Polytechnic University, 300387 Tianjin, China

 

2Key Laboratory of Advanced Textile Composite Materials, Tianjin Polytechnic University, 300387 Tianjin, China

 

3Key Laboratory of Hollow Fiber Membrane Material and Membrane Process of Ministry of Education, Tianjin Polytechnic University, 300387 Tianjin, China

 

4Textile Engineering Department, NED University of Engineering & Technology, 999010 Karachi, Pakistan

 

5Bioresources and Biorefinery Laboratory, Faculty of Science and Technology, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

6Fiber and Biocomposite Centre, Malaysian Timber Industry Board, 42700 Banting, Selangor Darul Ehsan, Malaysia

 

7Faculty of Science and Engineering, The University of Nottingham, 315100 Ningbo, China

 

Received: 19 April 2018/Accepted: 12 September 2018

 

ABSTRACT

Kenaf fibres demonstrate enormous potential in fibre reinforced composites with the excellent performance and environmental benefits. In this work, kenaf fibres were treated with NaOH at the concentrations of 1%, 2%, and 3%. Effects of the alkaline treatments on the mechanical properties of fibre and interfacial shear properties (IFSS) of the resulted composites were systematically evaluated. In addition, relationship between tensile strength and surface friction coefficient of kenaf fibre was shown. Relationship between tensile strength of fibre and IFSS of composites were explored. They were conducted by correlation analysis method. The results indicated that after NaOH treatment, kenaf fibres has increased in tensile strength, surface roughness, friction coefficient, but decreased in diameter. Tensile properties, flexural properties and water absorption of unidirectional kenaf fibre reinforced epoxy resin composites have improved. IFSS of composite treated at 2% alkali has increased by 10.34%, compared to composites untreated fibres. Correlation analysis indicated that there was no significant correlation between kenaf fibre tensile strength and IFSS of the composite. On the other hand, there was significant correlation between kenaf fibre surface friction and the IFSS of the composite with the correlation coefficient of 0.905.

 

Keywords: Correlation analysis method; interfacial shear strength (IFSS); NaOH; surface friction

 

ABSTRAK

Serabut kenaf menunjukkan potensi besar dalam pembuatan komposit diperkuat serabut disebabkan ia mempunyai prestasi cemerlang dan kesan positif kepada alam sekitar. Dalam kajian ini, serabut kenaf dirawat dengan natrium hidroksida (NaOH) pada kepekatan 1%, 2% dan 3%. Kesan rawatan alkali terhadap sifat mekanik serabut dan sifat geseran permukaan (IFSS) daripada komposit yang dihasilkan dinilai secara sistematik. Di samping itu, hubungan antara kekuatan tegangan dan koefisien geseran permukaan serabut kenaf telah dinyatakan. Hubungan antara kekuatan tegangan serabut dan IFSS komposit telah diterokai. Analisis dijalankan melalui kaedah analisis korelasi. Keputusan menunjukkan selepas rawatan NaOH 1%, serabut kenaf meningkat dalam kekuatan tegangan, kekasaran permukaan, koefisien geseran dan penurunan diameter. Sifat tegangan, sifat lentur dan penyerapan air komposit resin epoksi diperkuat serabut menunjukkan peningkatan. IFSS komposit dengan serabut yang dirawat dengan 2% alkali meningkat sebanyak 10.34%, berbanding komposit dengan serabut yang tidak dirawat. Analisis korelasi menunjukkan tiada korelasi yang ketara antara kekuatan tarik serabut kenaf dan IFSS komposit. Sebaliknya, terdapat hubungan yang signifikan antara geseran permukaan serabut kenaf dan IFSS komposit dengan koefisien korelasi sebanyak 0.905.

 

Kata kunci: Kaedah analisis korelasi; kekuatan geseran permukaan (IFSS); NaOH; permukaan geseran

REFERENCES

El-Shekeil, Y.A., Sapuan, S.M. & Khalina, A. 2012. Effect of alkali treatment on mechanical and thermal properties of kenaf fiber-reinforced thermoplastic polyurethane composite. Journal of Thermal Analysis and Calorimetry 109: 1435- 1443.

Fiore, V., Di Bella, G. & Valenza, A. 2015. The effect of alkaline treatment on mechanical properties of kenaf fibers and their epoxy composites. Composite Part B 68: 14-21.

Gomes, A., Matsuo, T., Goda, K. & Ohgi, J. 2007. Development and effect of alkali treatment on tensile properties of curaua fiber green composites. Composite Part A 38(8): 1811-1820.

He, S.H.H. 2013. Kenaf/aramid yarn and composite material preparation and properties research. TianJin: Tianjin Polytechnic University.

John, M.J. & Anandjiwala, R.D. 2008. Recent developments in chemical modification and characterization of natural fiber-reinforced composites. Polymer Composite 29(2): 187-207.

Li, X., Tabil, L.G. & Panigrahi, S. 2007. Chemical treatment of natural fiber for use in natural fiber-reinforced composites: A review. Journal of Polymers and the Environment 15(1): 25-33.

Liao, T.T., Liu, H. & Wu, H.W. 2011. Preparation and mechanical properties of discontinuous alkali treated sisal fiber reinforced PLA composites. China Plastics Industry 39(12): 93-97.

Ma, Y.F., Zhang, W., Wang, C. & Fuxiang, C.H.U. 2002. Progress in interfacial modification methods of natural fiber composites. Materials Review 25(19): 81-84.

Ming, C., Hitoshi, T., Antonio, N. & Nakagaito. 2016. Effect of alkali treatment on interfacial bonding in abaca fiber-reinforced composites. Composites: Part A 90: 589-597.

Misra, S.S., Ahankari, A.K. & Mohanty, A.D. 2011. Creep and fatigue of natural fiber composites. In Interface Engineering of Natural Fiber Composites for Maximum Performance, edited by Zafeiropoulos, N.E. Cambridge: Woodhead Publishing Limited. pp. 289-340.

Moyeenuddin, A., Sawpan, K.L. & Pickering, A.F. 2011. Effect of fiber treatments on interfacial shear strength of hemp fiber reinforced polylactide and unsaturated polyester composites. Composites: Part A 49(2): 1189-1196.

Mwaikambo, L.Y. & Ansell, M.P. 2002. Chemical modification of hemp, sisal, jute, and kapok fibers by alkalization. Journal of Applied Polymer Science 84(12): 2222-2234.

Mwaikambo, L.Y., Tucker, N. & Clark, A.J. 2007. Mechanical properties of hemp fiber reinforced euphorbia composites. Macromolecular Materials and Engineering 292(9): 993- 1000.

Nam, T.H., Ogihara, S. & Tung, N.H. 2011. Effect of alkali treatment on interfacial and mechanical properties of coir fiber reinforced poly(butylen succinate) biodegradable composites. Composites: Part B 42(6): 1648-1656.

Peng, D., Sun, Y.M. & Yang, L.X. 2011. Ramie fiber composite material and its application. New Chemical Materials 39(02): 26-28.

Rawal, A. & Sayeed, M.M.A. 2014. Tailoring the structure and properties of jute blended nonwoven geotextiles via alkali treatment of jute fibers. Materials & Design 53: 701-705.

Ray, D., Sarkar, B.K. & Rana, A.K. 2001. Effect of alkali treated jute fibers on composite properties. Bulletin of Materials Science 24(2): 129-135.

Reza, M., Jamaludin, B.M.Y. & Abdul, R.M.S. 2013. A review of structural performance of oil palm empty fruit bunch fiber in polymer composites. Advances in Materials Science and Engineering 4: 1-9.

Reza, M., Jamaludin, M.Y. & Abdul, R.M.S. 2014. Tensile properties of kenaf fiber due to various conditions of chemical fiber surface modifications. Construction and Building Materials 55(1): 103-113.

Reza, M., Jamaludin, M.Y. & Abdul, R.M.S. 2014. Characteristics of continuous unidirectional kenaf fiber reinforced epoxy composites. Materials and Design (64): 640-649.

Rokbi, M. 2011. Effect of chemical treatment on flexure properties of natural fiber reinforced polyester composite. Procedia Engineering 10: 2092-2097.

Saha, P., Manna, S. & Chowdhury, S.R. 2010. Enhancement of tensile strength of lignocellulosic jute fibers by alkali-steam treatment. Bioresour. Technol. 101(9): 3182-3187.

Sathishkumar, T.P., Navaneethankrishnan, P. & Shankar, S. 2012. Tensile and flexural properties of snake grass natural fiber reinforced isophthallic polyester composites. Composites Science and Technology 72(10): 1183-1190.

Scarponi, C., Schiavoni, E. & Sanchez-Saez, S. 2012. Polypropylene/hemp fabric reinforced composites: Manufacturing and mechanical behaviour. Journal of Biobased Materials and Bioenergy 6(4): 361-369.

Tim, H., Jörg, M. & Owen, C. 2012. A critical review of all-cellulose composites. Journal of Materials Science 47(3): 1171-1186.

Valadez, G.A. 1999. Effect of fiber surface treatment on the fiber-matrix bond strength of natural fiber reinforced composites. Composites Part B 30(3): 309-320.

Wang, C.H.H., Ren, Z.L. & Zhang, Q.J. 2017. Effect of surface modification of unidirectional bamboo fiber on theproperties of its reinforced unsaturated polyester resin composites. Acta Materiae Compositae Sinica 34(2): 314-321.

Wang, C.H., Liu, S. & Ye, Z.H.L. 2016. Mechanical, hygrothermal ageing and moisture absorption properties of bamboo fibers reinforced with polypropylene composites. Journal of Reinforced Plastics and Composites 35(13): 1062-1074.

Wang, C.H.H. & Liu, S.H.K. 2015. Effect of alkali treatment on properties of bamboo fiber and bamboo fiber reinforced polypropylene composites. Acta Materiae Compositae Sinica 32(3): 683-690.

Wang, L.L., He, L.P. & Tian, Y. 2008. Effects of surface modification on mechanical properties of sisal fiber reinforced polypropylene composites. Journal of Mechanical Engineering Materials 32(5): 58-61.

Xue, L., Lope, G.T. & Satyanarayan, P. 2007. Chemical treatments of natural fiber for use in natural fiber-reinforced composites: A review. Journal of Polymers and the Environment 15(01): 25-33.

 

*Corresponding author; email: cn_wangch@163.com

 

 

 

previous