Sains Malaysiana 49(12)(2020): 3169-3177

http://dx.doi.org/10.17576/jsm-2020-4912-28

 

The Influence of Temperature and Electroforesis Deposition Green Inhibitor on Bipolar Plate AA5052 in Sulfuric Acid Medium

(Pengaruh Suhu dan Endapan Elektroforesis Perencat Hijau pada Plat Dwikutub AA5052 dalam Asid Sulfurik)

 

I GUSTI AYU ARWATI1,3, EDY HERIANTO MAJLAN1*, LOH KEE SHYUAN1, TEUKU HUSAINI1, SAGIR ALVA3, MUHAJIRIN3 & NABILAH AFIQAH MOHD RADZUAN2

 

1Fuel Cell Institute, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

2Centre for Materials Engineering and Smart Manufacturing, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

3Engineering Faculty, Mercu Buana University, 11650 Jakarta Barat, Indonesia

 

Diserahkan: 4 Ogos 2020/Diterima: 11 September 2020

 

ABSTRACT

Aluminum alloy 5052 (AA5052) contains Mg (2.2-2.8.8% weight), Cu (0.1% weight), Cr (0.15% weight), Zn (0.1% weight), Si and Fe (0.45% weight) compositions. This material has been widely used as a bipolar plate in Proton exchange Membrane (PEMFC) fuel cells. This material has several advantages such as: lightness, high conductivity, good tensile strength, and flexibility. PEMFC operations produce several by-products, such as water and heat. Generally, the operation of PEMFC is around 333-353 K and the environment is acidic. In this condition the bipolar plate AA5052 will easily experience rust, thus lowering the performance of the PEMFC. In this study, 0.5 g/L Arabic Gum (AG) used as a green inhibitor and coated onto the AA5052 surface through electrophoretic deposition (EPD). The corrosion test was performed in 0.5 M H2SO4 (pH 2) solution under the simulated PEMFC condition. Scanning electron microscopy (SEM) was used to analyze the morphology, and potentiodynamic polarization to determine the corrosion rate. Result shows that AG coating can reduce 60% the corrosion rate of AA5052 after immersed in 0.5 M H2SO4 for 168 h. The effect of temperature on the inhibition efficiency reached 14.4% under the same condition. AG can be used as a green inhibitor to reduce the corrosion rate of AA5052 bipolar plate.

 

Keywords: Aluminum alloy 5052; Arabic Gum inhibitor; corrosion rate; electrophoretic deposition

 

ABSTRAK

Aloi aluminium 5052 (AA5052) mengandungi komposisi Mg (2.2-2.8.8% berat), Cu (0.1% berat), Cr (0.15% berat), Zn (0.1% berat), Si dan Fe (0.45% berat). Bahan ini telah digunakan secara meluas sebagai plat dwikutub untuk sel fuel membran pertukaran proton (PEMFC). Bahan ini digunakan kerana kelebihannya, seperti ringan, kekonduksian tinggi, kekuatan tegangan yang baik dan kefleksibilannya. Operasi PEMFC menghasilkan beberapa produk sampingan seperti air dan haba. Secara amnya, PEMFC beroperasi pada suhu 333-353 K dan mempunyai persekitaran yang berasid. Plat dwikutub AA5052 ini akan mudah mengalami karat, sehingga menurunkan prestasi PEMFC. Dalam kajian ini, 0.5 g/L Gam Arab (GA) digunakan sebagai perencat hijau dan dilapisi ke permukaan AA5052 melalui pemendapan elektroforetik (EPD). Ujian kakisan dilakukan dalam larutan 0.5 M H2SO4 (pH 2) sesuai dengan simulasi keadaan PEMFC. Mikroskopi elektron imbasan (SEM) digunakan untuk menganalisis morfologi dan polarisasi potensiodinamik untuk menentukan kadar kakisan. Hasil menunjukkan bahawa lapisan AG dapat mengurangkan 60% kadar kakisan AA5052 setelah direndam dalam 0.5 M H2SO4 selama 168 jam. Kesan suhu pada kecekapan penghambatan mencapai 14.4% dalam keadaan yang sama. AG boleh digunakan sebagai perencat hijau untuk mengurangkan kadar kakisan AA5052.

 

Kata kunci: Aloi aluminium 5052; kadar kakisan; pemendapan elektroforesis; perencat Gam Arab

 

RUJUKAN

Ameh, P.O. 2014. Inhibitory action of Albizia zygia gum on mild steel corrosion in acid medium. African Journal of Pure and Applied Chemistry 8(2): 37-46.

Arwati, I.A., Majlan, E.H., Daud, W.R.W., Shyuan, L.K., Arifin, K., Husaini, T., Alva, S. & Radzuan, N.A.M. 2019. Electrophoresis deposition Arabic Gum effect on aluminum 5052 reduce corrosion. Sains Malaysiana 48(2): 401-406.

Arwati, I.A., Majlan, E.H., Daud, W.R.W. & Alva, S. 2018. Temperature effects on stainless steel 316L corrosion in the environment of sulphuric acid (H2SO4). IOP Conference Series: Materials Science and Engineering 343(012016): 1-8.

Azzaoui, K., Mejdoubi, E., Jodeh, S., Lamhamdi, A., Rodriguez-Castellón, E., Algarra M., Zarrouk, A., Errich, A., Salghi, R. & Lgaz, H. 2017. Eco friendly green inhibitor Gum Arabic (GA) for the corrosion control mild steel in hydrochloric acid medium. Corrosion Science 129: 70-81.

Besra, L. & Liu, M. 2007. A review on fundamentals and applications of electrophoretic deposition (EPD). Progress in Materials Science 52(1): 1-61.

Bhowmik, A., Srivas, S.P. & Khandelwal, A.K. 2016. A review of the properties aluminium alloy 5052. Journal of Scientific Research in Allied Science 2(2) 25-30.

Boccacini, A.R., Keim, S., Ma, R., Li, Y. & Zhitomirsky, I. 2010. Review: Electrophoretic deposition of biomaterials. Journal of the Royal Society Interface 7(5): 581-613.

Chiang, T.Y., Su, A., Tsai, L.C., Sheu, H.H. & Lu, C.E. 2014. Corrosion resistance of 5052 Al-alloy with a Zirconia-rich conversion coating used in bipolar plates in PEMFCs. International Journal of Electrochemical Science 9: 5850-5863.

Choudhary, B., Anwar, S., Besra, L. & Anwar, S. 2017. Electrophoretic deposition studies of Ba(Zr-Ce-Y)O3 ceramic coating. International Journal of Applied Ceramic Technology 16(3): 1022-1031.

Dalo, M.A., Othman, A. & Al-Rawashdeh, N.A.F. 2012. Exudate gum from acacia trees as green corrosion inhibitor for mild steel in acidic media. International Journal of Electrochemical Science 7: 9303-9324

Dariva, C.G. & Galio, A.F. 2014. Corrosion inhibitors - principles, mechanisms and applications. In Developments in Corrosion Protection, edited by Aliofkhazraei, M. Rijeka: InTech. pp. 365-379.

Denni Asara Awizar, Norinsan Kamil Othman, Azman Jalar, I. Abdul Rahman & N.H. Al-hardan. 2013. Nanosilicate extraction from rice husk ash green corrosion inhibitor. Journal of Elechtrochemical Science 8: 1759-1769.

Gharavi, F., Matori, K.A., Yunus, R., Othman, N.K. & Fadaeifard, F. 2015. Corrosion behavior of Al6061 alloy weldment produced by friction stir welding process. Journal of Materials Research and Technology 4(3): 314-322.

González Gutiérrez, A.G., Sebastian, P.J., Magallón Cacho, L., Borja Arco, E., Campos, J. & Baron, A. 2018. Surface modification of aluminum alloy 6061 for bipolar plate application: Adhesion characteristics and corrosion resistance. International Journal of Electrochemical Science 13: 3958-3969.

Huang, N.B., Yu, H., Xu, L.S., Zhan, S., Sun, M. & Kirk, D.W. 2016. Corrosion kinetics of 316L stainless steel bipolar plate with chromium carbide coating in simulated PEMFC cathodic environment. Results in Physics 6: 730-736.

Khan, G., Kazi, S.N., Basirun, W.J., Ali, H.B.M., Faraj, F.L. & Khan, G.M. 2015. Application of natural product extracts as green corrosion inhibitors for metals and alloys in acid pickling processes - a review. International Journal of Electrochemical Science 10: 6120-6134.

Pech-Rodríguez, W.J., González-Quijano, D., Vargas-Gutiérrez, G. & Rodríguez-Varela, F.J. 2014. Electrophoretic deposition of polypyrrole/Vulcan XC-72 corrosion protection coatings on SS-304 bipolar plates by asymmetric alternating current for PEM fuel cells. International Journal of Hydrogen Energy 39(29): 16740-16749.

Sagir Alva, Aiman Sajidah binti Abdul Aziz, Mohd Ismahadi bin Syono & Wan Adil bin Wan Jamil. 2018. Ag/AgCl reference electrode based on thin film of Arabic Gum membrane. Indonesian Journal of Chemistry 18(3): 479-485.

Sutharssan, T., Montalvao, D., Kang, Y., Wang, W., Pisac, C. & Elemara, H. 2017. A review on prognostics and health monitoring of proton exchange membrane fuel cell. Renewable and Sustainable Energy 75: 440-450.

Taherian, R. 2014. A review of composite and metallic bipolar plates in proton exchange membrane fuel cell: materials, fabrication, and material selection. Journal of Power Sources 265: 370-390.

Umoren, S.A. & Eduok, U.M. 2016. Application of carbohydrate polymers as corrosion inhibitors for metal substrates in different media: A review. Carbohydrate Polymer 140: 314-341.

Vadivelan, M.R., Kumar, N.S. & Balaji, R. 2015. A review on corrosion of metallic bi-polar plates for proton exchange membrane (PEM) fuel cells. IOSR Journal of Mathematics 11(6): 83-99.

Yang, Y., Guo, L.J. & Liu, H. 2011. Corrosion characteristics of SS316L as bipolar plate material in PEMFC cathode environments with different acidities. International Journal of Hydrogen Energy 36(2): 1654-1663.

Zhang, D., Duan, L., Guo, L., Wang, Z., Zhao, J., Tuan, W.H. & Niihara, K. 2011. TiN-coated titanium as the bipolar plate for PEMFC by multi-arc ion plating. International Journal of Hydrogen Energy 36(15): 9155-9161.

 

*Pengarang untuk surat-menyurat; email: edyhm71@gmail.com

   

 

sebelumnya