Sains Malaysiana 47(4)(2018): 853-859

http://dx.doi.org/10.17576/jsm-2018-4704-25

 

Kecekapan Pengumpul PV/T Menggunakan Pengumpul Terma Reka Bentuk Pilin

(Efficiency of PV/T Collector using Spiral Thermal Absorber Design)

 

CHEKU NURUL AISYAH, AHMAD FUDHOLI*, MOHD YUSOF OTHMAN, ADNAN IBRAHIM, MOHD HAFIDZ RUSLAN & KAMARUZZAMAN SOPIAN

 

Solar Energy Research Institute, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor Darul Ehsan, Malaysia

 

Diserahkan: 18 September 2017/Diterima: 8 November 2017

 

ABSTRAK

 

Kajian ini bertujuan untuk mereka bentuk dan mengkaji prestasi pengumpul fotovoltan-terma (PV/T) dengan menggunakan reka bentuk pengumpul terma aliran air secara pilin. Reka bentuk pengumpul terma aliran air secara spiral telah dibina semula daripada reka bentuk penyelidik sebelum ini. Pengumpul terma ini menggunakan saiz tiub yang lebih besar dan jarak antara tiub lebih dekat berbanding dengan reka bentuk penyelidik sebelum ini. Pengumpul PV/T ini telah diuji di bawah tiga keamatan yang berbeza iaitu 300, 500 dan 700 W/m2 serta diuji pada kadar aliran jisim air yang berbeza iaitu 0.01, 0.02 dan 0.04 kg/s. Pada keadaan yang sama, kecekapan fotovoltan, terma dan tergabung juga menunjukkan nilai yang paling tinggi, iaitu 4.18%, 76.68% dan 80.86%. Kecekapan terma yang dihasilkan pada kajian ini lebih tinggi dibandingkan dengan kajian sebelumnya.

 

Kata kunci: Elektrik; kecekapan; tenaga suria; terma

 

ABSTRACT

 

This study aimed to design and assess the photovoltaic-thermal (PV/T) collector performance using spiral thermal collector design. The design of the spiral water collector was rebuilt from previous researchers design. The thermal collectors use a larger tube size and the distance between the tubes closer than with previous researchers design. PV/T collector has been tested under three different intensities, which are 300, 500 and 700 W/m2 and also tested at three different water mass flow rates, which are 0.01, 0.02 and 0.04 kg/s. At the same circumstances, the efficiency of photovoltaic (PV), thermal and PV/T also shows the highest value, which are 4.18%, 76.68% and 80.86%. In this study, the result of thermal efficiency is higher than the previous study.

 

Keywords: Efficiency; electrical; solar energy; thermal

 

RUJUKAN

Aste, N., Del Pero, C. & Leonforte, F. 2014. Water flat plate PV/Thermal collector: A review. Solar Energy 102: 98-115.

Chow, T.T.,  He, W.  &  Ji,  J.  2006. Hybrid   photovoltaic-thermosyphon water heating system for residential application. Solar Energy 80: 298-306.

Dupreyat, P., Menezo, C. & Fortuin, S. 2014. Study of the thermal and electrical performances of PVT solar hot water system. Energy and Buildings 68: 751-755.

Fudholi, A., Sopian, K., Yazdi, M.H., Ruslan, M.H., Ibrahim, A. & Kazem, H.A. 2014. Performance analysis of photovoltaic thermal (PVT) water collectors. Energy Conversion and Management (78): 641-651.

Ibrahim, A., Fudholi, A., Sopian, K., Othman, M.Y. & Ruslan, M.H. 2014. Efficiencies and improvement potential of building integrated photovoltaic thermal (BIPVT) system. Energy Conversion and Management 77: 527-534.

Ibrahim, A., Othman, M.Y., Ruslan, M.H., Alghoul, M.A., Yahya, M., Zaharim, A. & Sopian, K. 2009. Performance of photovoltaic thermal collector (PVT) with different absorbers design. WSEAS Transaction on Environment and Development 5(3): 321-330.

Ji, J., Lu, J.P., Chow, T.T., He, W. & Pei, G. 2007. A sensitivity study of a hybrid photovoltaic/thermal water-heating system with natural circulation. Applied Energy 84(2): 222-237.

Kim, J.H. & Kim, J.T. 2012a. The experimental performance of an unglazed PVT collector with two different absorber types. International Journal of Photoenergy 2012: 1-6.

Kim, J.H. & Kim, J.T. 2012b. The experimental performance of an unglazed PV-thermal collector with a fully wetted absorber. Energy Procedia 30: 144-151.

Mishra, R.K. & Tiwari, G.N. 2013. Energy and exergy analysis of hybrid photovoltaic thermal water collector for constant collection temperature mode. Solar Energy 90: 58-67.

Sadishkumar, S. & Balusamy, T. 2014. Performance improvement in solar water heating sistems - A review. Renewable and Sustainable Energy Reviews 37: 191-198.

Sandnes, B. & Rekstad, J. 2002. A photovoltaic/thermal (PV/T) collector with a polymer absorber plate: Experimental study and analytical model. Solar Energy 72: 63-73.

Tripanagnostopoulos, Y., Nousia, T., Souliotis, M. & Yianoulis, P. 2002. Hybrid photovoltaic/thermal solar systems. Solar Energy 72(3): 217-234.

Zondag, H.A. 2008. Flat-plate PV-Thermal collectors and systems: A review. Renewable Sustainable Energy Reviews 12: 891-959.

Zondag, H.A., de Vries, D.W., van Helden, W.G.C., van Zolingen, R.J.C. & van Steenhoven, A.A. 2003. The yield of different combined PV-thermal collector designs. Solar Energy 74: 253-269.

 

*Pengarang untuk surat-menyurat; email: a.fudholi@gmail.com

 

 

 

 

 

 

 

sebelumnya